185824 - p-System High-Performance Shank-Type Cutters CM DP - Weeke BHX 050/055
Technical data
Description
Machine / Application
- WEEKE BHX 050 and BHX 055 with delivery date as from Sept. 01, 2015
- BHX 50/055 machines with CNC controlled clamping devices (servo) and with delivery date as from 01.01.2014 only can be updated by the manufacturer (Note: Service charges will occur)
- for chip-free high-performance jointing and dividing of solid woods (free of knots) along and accross the grain
- for jointing and dividing of melamine-, paper-, HPL-laminated, foiled and veneered panels and lacquered surfaces
- Finish-quality in the case of fiber materials such as fabric-laminated panels, linoleum with jute fibers, cork etc.
Design
- extremely scoring cut
- asymmetrical design
- DP plunge tip
Advantages
- maximum cutting quality and edge lives
- chip-free cuts even on the exit side
- increased contact pressure than conventional shank-type cutters
Notes
- Tools with plunge tip (L4) must project at least 4,5 mm on bottom side of workpiece in order to bring p-System cutting edges into action. D 30 is without plunge tip
- for ramping or circular plungeing only
- recommended feed rate per tooth: wood-based panels 0.3 - 0.35 mm, solid wood 0.15 - 0.2 mm
- clamping element: precision clamping element e.g. ps-System, TRIBOS
- with thread for length adjusting screw
- sense of rotation according to VDMA 8849
Feature | Value | |
---|---|---|
Ø D = Cutting circle diameter | 25 [mm] | |
L4 = Cuttind width 1 | 4 [mm] | |
L2 = Cutting width | 47,2 [mm] | |
Ø d = Shank diameter | 25 [mm] | |
L3 = Shank length | 53 [mm] | |
L1 = Total length | 125 [mm] | |
Z = No. of teeth | 2+2+1 | |
nmax = maximum RPM | 24,000 [min-1] | |
Shear∡ = Shear angle | 70 [°] | |
Resharpening area = Resharpening area | 2.5 [mm] | |
L/R = cutting direction | R | |
L = Delivery Status | ||
Dimensions entered are not listed?
available from stock |